Popular method of generating DIY CO2 is to use a citric acid and baking soda (aka bicarbonate of soda, aka sodium bicarbonate).
The pressure in the bottles will want to form an equilibrium because they are connected by tubing. So when the pressure is higher in bottle A than in bottle B, gas will want to flow from A to B. A consequence of this is that citric acid is injected into bottle B when the pressure in bottle A becomes higher than that in bottle B, which in turn creates more CO2. This additional gas is pushed into bottle A (as well as your diffuser), again making an equilibrium but in reverse to before. When the pressure in B falls below A, citric acid is again pushed from A to B, and so the cycle continues. It’s an ingenious system!
INSTRUCTIONS FOR DIY CO2 USING BAKING SODA AND CITRIC ACID
2 x 2L Plastic Bottles, e.g. Coke or Sprite.
Bottle A
200g Citric Acid Powder.
Mix with 600ml Water until dissolved.
Bottle B
200g Baking Soda
Mix with 200ml Water until dissolved.
To start, citric acid or vinegar is poured into bottle A, and a mixture of baking soda and water is poured in bottle B. The caps with tubing attached are then screwed onto the bottles.
The needle valve is opened, and bottle A is squeezed slightly to inject Citric Acid into bottle B. This starts the generation of CO2. The needle valve is then closed to allow pressure to build in the bottles.
Mix bottle B by swirling the mixture around – you should see some bubbling. If not, squeeze some more citric acid from bottle A.
When the pressure gauge reads 1.5 bar in bottle A you can slowly open the needle valve to begin the flow of CO2 to your diffuser.
Note:
1.Don’t open bottle directly when there’s still on pressure, please wait for its automatic pressure release.
2.Please use food-grade citric acid and baking soda as the raw material.
3. For more specific instructions and usage, please read our English user manual.
4.The initial set of safety vavle is 4kg/c, you can also adjust it manually.
Specifications:
Cap Material: ABS Plastic
PipePU Plastic
Air Flow Adjustment Valve: ABS Plastic + Stainless Steel
PU Connecting Pipe Length: 160cm
Item Weight: 143g
Package Size: 18.5 * 13 * 4.5cm
Package Weight: 200g














Reviews
There are no reviews yet.